台式电动离心机产品概述：

800台式电动离心机

800型台式电动离心机具有造型美观，容量大，体积小、功能齐全。其性能稳定，速度可调并能自动调节平衡，温升低使用效率高，以及适用性广等特点。
　该产品适用于医药制品、血站、临床试验及生物化学实验室作血清、血浆、尿素的定性分析。
一、800台式电动离心机技术参数
型号:800电动离心机
调速范围（rpm）:0～4000
容量（ml）:20×6
离心力（xg）:1430
电源:220V 50HZ

800D Desk centrifugal settler

Based on the 800 settler, this centrifugal settler belonging to advanced generation with many advantages including beautiful appearance、small volume、light weight、high capacity, so it applies to the qualitative analysis of plasma and serum in hospital labouratory and biochemistry laboratory as well as the carbamide and vaccine processing.

Technical parameters:

1，Power supply: 110V 50Hz

2, Timing range:0-60min

3, Rated power:50W

4: Speed range:0-4000 r/min

5, Capacity: 20ml X6(Angie type)

6, Separating factor:1430

Important Notice：

For your safety, a reliable grounding is strongly recommended to be done before operation,
Before the first time use, please read this Operation Manual carefully.
Working conditions: 0-40℃ ambient temperature and 80% below relative humidity.
It is suggested to cut off power when long term nonuse.

Operation Procedure:

Insert the plug into socket and turn on the power switch.
Put the medicine into centrifuge tube and then insert the tube into the corresponding sleeve, close the cover plate and select proper centrifugal speed according to test requirements, then select running time or close ON. So it is easy to operate this instrument with better effect.

Daily maintenance

Correct operation and maintenance can extend the service life, it is suggested to place this instrument under reasonable working conditions so that the instrument can work normally.
If the liquid is splashed or sprayed into instrument by accident, cut off the power supply and remove the residual liquid in case shorten the service life.

One year warranty and lifelong maintenance are offered to our product (reasonable labor and material cost will be triggered by man-made damage or misoperation

二、800电动离心机安全须知

严禁在未装转头的情况下空载运行;运行之前应检查转头有无腐蚀损伤;当转头运行时不要接触正在运行的转头;严禁转头在装载不平衡的状态下运转。

三、800电动离心机使用说明

离心机的工作台应平整坚固,工作间应整齐清洁,干燥并通风良好,环境温度以5-32°C为宜.开启离心机将内腔及转头擦拭干净.装放称量*的试管,关闭离心机盖,调节调速旋钮,升至所需转速.每次停机前,必须将调速旋钮置于zui小位置.“定时器”置“零”关电源开关,切断电源.擦拭内腔及转头,关闭离心机盖。