Replaent Accessories
Standard screw set
Part code:
HFRSS
Gasoline screw set
Part code:
HFRGSS
Tool set
Part code:
HFRTOOL
Pack containing - Tool Set, Screw set & Weight hanger cord
Part code:
HFRTSW
Weight Hanger cord
Part code:
HFRWHC
Upper and Lower Specimen Holders
Weight Set
Part code: HFRWT
Main Temperature Probe
Part code: HFRMRTD
Push Rod Insert
Part code: HFRPRI
Heater Block
Part code: HFRHB
Alarm RTD
Part code: HFRARTD
Heaters
Part code: HFRHEAT15
HFRR Humidity and Temperature probe including cable & bracket
Part code: HFRHYG
Overview
Important Information
Verification
Overview
HFRR Connecting Cable and Humidity/Temperature Probe
An optional combined humidity and temperature probe can be connected to the rear of the HFRR control unit. For some test procedures the wear scar must be adjusted to compensate for the effect of fuel moisture content on the result. The probe will automatically measure the ambient temperature and humidity at the start and end of the test, instead of the user having to make the measurements manually.
Supplied components
HFRR Humidity and Temperature probe
Probe connecting cable
Probe bracket (not required if using an HFRR Humidity Controlled Cabinet )
If the instrument is being used with a humidity controlled cabinet the probe should be located in the provided fitting on the left side of the cabinet. If the instrument is not being used with a humidity controlled cabinet, a bracket is supplied with the probe to enable the probe to be connected to the side of the mechanical unit.
HFRR Probe & Bracket
The bracket supplied is fitted to the right hand side of the instrument (when viewed from the test chamber end) using the front cover screw as shown above.
The HFRR humidity and temperature probe can be purchased separay without cable and bracket. The part code for this item is HFRHUM.
英国PCS柴油润滑性仪器备件
英国PCS柴油润滑性仪器备件
所有评论仅代表网友意见,与本站立场无关。