BAY51-2*40W防爆荧光灯，CBY52防爆抽芯式荧光灯 防爆荧光灯，BAY51-2*40W，防爆抽芯式荧光灯，CBY52防爆荧光灯

BAY51-2*40W防爆荧光灯用途与使用范围

BAY51-2*40W防爆荧光灯技术参数

带应急荧光灯技术参数

BAY51-2*40W防爆荧光灯主要结构
The main structure
荧光灯由灯具和接线盒两部分组成，灯具两端用铸铝合金压铸外壳，表面喷塑，灯芯部分为一整体，包括支架、灯管、镇流器、启辉器等，更换灯管时先断开电源，然后打开端盖，断开安全电源插头，将灯芯部分整体抽出。把灯管向弹簧侧移动后，可将灯管取下。荧光灯外部装有防尘罩。荧光灯为复合型结构，灯具主腔为隔爆型结构，接线腔为增安型。接线盒为隔爆型，电缆采用直接引入方式，电缆引入装置从内到外依次装有密封圈、垫圈和压紧螺母，适合电缆或钢管布线。接线盒设有内接地螺钉，灯具设有外接地螺钉。
The fluorescent lamp comprises a lamp and the junction box is composed of two parts, lamp at both ends of cast aluminum alloy die casting shell, surface spray, the wick part as a whole, comprises a bracket, lamp, ballast, starter, replacement of lamp to disconnect the power, and then open the side cover, disconnect the safety power supply plug, the wick is part of a whole extract. The lamp tube to move the spring side, a luminous tube can be removed. Fluorescent lamp is arranged outside of the dust cover. Fluorescent lamp is a composite structure, the main chamber lamps for flameproof structure, wiring cavity is Increased-Safety type. Junction boxes for explosion-proof type, the direct introduction of cable, cable introducing device from the inside to the outside is provided with a sealing ring, a washer and nut, suitable for cable or steel pipe wiring. The junction box is provided with a grounding screw, lamp equipped with external screw.
BAY51-2*40W防爆荧光灯使用与维修
5 use and repair
5.1安装前应检查荧光灯铭牌上所列数据是否与实际使用条件相符；
5.1 installation should be checked before the fluorescent lamp nameplate on the column data is consistent with the actual conditions of use;
5.2应检查电缆外径是否适合密封圈尺寸；
5.2 should check the cable diameter is suitable for the size of the seal ring;
5.3安装前，将接线盒盖和灯具引入装置打开，把电缆一端接接线盒内接
5.3 before installation, the junction box and lamp into the device is opened, the cable is connected to the junction box inscribed
线端子上，把电缆另一端穿过管接头及垫圈、密封圈到灯具接线腔内接到接线端子上，将各部分连接好，把连接好的荧光灯固定在使用位置，把电源电缆线依次穿过引入装置的压紧螺母、垫圈和密封圈接至接线盒内接线端子上，接好接地线，紧固压紧螺母使电缆密封，不用的引入装置用堵棒、密封圈及压紧螺母密封好。合上接线盒盖，紧固好螺栓即可使用；
Line terminal, the other end of the cable through the pipe joint and gasket, sealing ring to the lamp wiring cavity to the terminal, each part is connected, the fluorescent lamp is connected well fixed in position, the power supply cable passes through the device of pressing nut, the gasket and sealing ring is connected to the terminal box terminal, connect the ground wire, fastening nut so that the cable sealing, introducing device without with blocking rod, sealing ring and a pressing nut sealed. Close the terminal cover, fastening bolts can be used;
5.4荧光灯不得随意拆卸，维修时先断开前级电源后，才能开盖维修。打开端盖，断开安全电源插头，将灯芯部分整体抽出。注意：只有在拔掉插头后，才能把灯芯部分抽出。把灯管向弹簧侧移动后，可将灯管取下。维修时不得损坏隔爆面，维修后隔爆接合面清理后涂204-1防锈油，将端盖合上，各部分螺栓（钉）紧固后才能使用；
The 5.4 fluorescent lamps shall not disassemble, repair to disconnect the power supply before class, can open the cover repair. Open the cover, disconnect the safety power plug, the wick is part of the overall extraction. Note: only pull the plug, to put the wick part out. The lamp tube to move the spring side, a luminous tube can be removed. Repair shall not be damaged flameproof surface, after the repair of flameproof joint after cleaning with 204-1 antirust oil, the end cover is closed, the bolt （screw） fastening to use;
5.5荧光灯应定期检查，发现电缆引入装置的密封圈及密封垫老化变质及其他零件损坏应及时更换；
5.5 fluorescent lamp should be regularly checked, found the ring cable introducing device and a seal gasket aging deterioration and other parts damaged should be replaced promptly;
5.6带应急功能荧光灯接线应使控制器始终处于供电状态，给电池充电，断电时电池组能立即向灯管供电，在出厂后，若没有使用应每隔2~3个月充电一次，充电时间不能少于24h。
5.6 with emergency function of fluorescent lamp wiring should make the controller is always in the state of power supply, battery, power battery can immediay to the lamp power supply, at the factory, if not used should be every 2~3 months on a charge, the charging time of not less than 24h.
BAY51-2*40W防爆荧光灯外形及安装尺寸
6 appearance and installation dimensions
产品型号 L1 L2 产品型号 L1 L2
The product model L1 L2 product model L1 L2
BAY51-1×20 673.5 779 BAY51-2×20 677.5 779
BAY51-1 × 20673.5779 BAY51-2 × 20677.5779
BAY51-1×30 978.5 1084 BAY51-2×30 982.5 1084
BAY51-1 × 30978.51084 BAY51-2 × 30982.51084
BAY51-1×40 1383.5 1389 BAY51-2×40 1387.5 1389
BAY51-1 × 401383.51389 BAY51-2 × 401387.51389

专业生产：防爆配电箱,铸铝防爆箱,不锈钢防爆箱,防爆接线箱,防爆照明配电箱,防爆动力配电箱,防爆配电柜,防爆控制箱,BZC51防爆操作柱,防爆应急灯,防爆荧光灯,防爆无极灯厂家,防爆正压柜,防爆投光灯,柳市防爆箱,防爆断路器等，质量三包，凡购买本公司产品，质保三年，本公司证件齐全，价格实惠！