高温导热油泵ら常州市武研热油泵有限公司ら高温导热油泵的回装需要注意的地方：6.均匀地紧好各主螺栓，注意应该对角进行；7.在轴上吸一块表，旋转轴对平衡盘进行打表，允差要按图纸要求，一般不能超过0.06；8.装止推轴承时要注意调整平衡盘的间隙，应利用轴承前的调整环将平衡盘间隙调整至图纸要求。WRHeat conducting oil pump back loaded areas need to pay attention to: 6. Uniformly nice and tight the bolt, attention should be diagonal. On the shaft ceiling a dial indicator, rotation axis of balance disc to play table, the tolerance to according to the requirements of the drawings, should pay attention to adjust the balance disc is generally not more than 0.06; 8. Install the check thrust bearing clearance should be using the front bearing adjusting ring will balance disc gap is adjusted to the requirements of the drawings.

常州市武研热油泵有限公司
地 址：常州市武进区横林镇横玉路247号
销 售：,
售 后：
传 真：
手 机：
: 876363125
邮 箱：WRY@vip.163.com
常州高温导热油泵：www.wry006。。ｃｏｍ
WRY导热油泵：www.wry002。。ｃｏｍ
离心式热油泵：www.wry008。。ｃｏｍ
常州WRY热油泵：www.wry003。。ｃｏｍ
友情链接：耐腐蚀化工泵 www.wyryb。。ｃｏｍ
锅炉辅机：www.whboiler。。ｃｏｍ
刮板出渣机：www.cz-boiler。。ｎｅｔ
主动/被动炉排片：www.glfj。。ｎｅｔ
提升式上煤机：www.wh-boiler。。ｃｏｍ
武研导热油泵：http://wrypump.cn.alibaba.com
锅炉辅机配件：http://glboiler.cn.alibaba.com

2015.8.5张