Buehler镶嵌机SimpliMet 3000型产品特点：
可编程性降低复杂性
· 适用于有多种镶嵌样需求且镶嵌尺寸不同的实验室。
· 存储和撤销5种不同的程序，降低复杂性和消除错误， 提供灵活性来满足多变的实验室要求
通过选择不同尺寸的模具来优化各种各样的试样大小。节约镶嵌介质并提升镶嵌质量
| Specifications |
|
| Operation | Automatic electro-hydraulic |
| Power Source | 85-264VAC, 50/60Hz, 1 phase |
| Molding Pressure | 1200 - 4400psi [80 - 300bar] in 100psi [5bar] increments |
| Molding Temperature | 120 - 360°F [50 - 80°C] in 20°F [10°C] increments |
| Heating Power | 1500Watt @ 115/230VAC |
| Heating Time | 0 - 20 minutes in 10 second increments |
| Cooling Time | 0 - 30 minutes in 10 second increments |
| Mold Type | Cylindrical, including upper and lower rams and duplex mold spacer |
| Closure Type | Insluated bayonet with piston indent |
| Mold Diameters | 1in, 1.25in, 1.5in, 2in, 25mm, 30mm, 40mm, 50mm |
| Touch-pad Controls | On/Off; Heat Time; Cool Time; Molding Temperature; Molding Pressure; Mold Size; Ram Up/Down; Maunal Cool; Cycle Start; Cylinder Open; Unit of Measure; Language and also including Thermoplastic; Load and Save Methods |
| Units of Measure | Imperial or Metric |
| Water Flow Rate | 0.5gal/min [2ℓ/min] minimum |
| Water Pressure | 45-75psi [3-5bar] |
| Control Voltage | 24VDC |
| Method Programmability | 4 Buehler, Preprogrammed Methods per mold size; 25 User Definable Methods |
| Preload Pressure | 0 - 400psi [0 - 30bar] in 50psi [5bar] increments |
| Thermoplastic Function | Automatically sets correct parameters for thermoplastic resins such as TransOptic™ and cools the mount in a controlled, linear fashion |
| Compliance | In accordance with EC Directives |
所有评论仅代表网友意见，与本站立场无关。